Cyclades PR2000 Manual de Instalação descarregar pdf (Página 12)

12Chapter 3 Software Installation

cd pc300-<version> (to go to the newly created directory)

NOTE: at this point you should read the file README included in the directory pc300-<version> to

learn about any changes implemented since this manual was produced.

sh install (to run the install script)

This script will detect the system information (kernel version, current Cyclades-PC300 driver version, etc.) and

install the proper driver package files.

If an older version of the PC300 driver already exists, the files pc300.c, pc300.h, hd64572.h and falc-lh.h are

backed up with modified names in the same directory. If a newer version is already installed, the files will not be

updated with those of the older driver.

Configure the kernel by executing “make config” or “make menuconfig”:

Please note the following before beginning the kernel configuration. The only difference between

selecting Y/* or M is the following: Y/* causes the driver to be compiled as part of the kernel and is

activated every time the computer is booted; M creates the driver as a module, which can be

loaded or unloaded with a command without the need to reboot the computer.

The left column presents the commands and parameters that should be followed when using make config.

The right column provides the corresponding commands and parameters for make menuconfig.

cd /usr/src/linux cd /usr/src/linux

make config make menuconfig

For kernels 2.0.x:

CONFIG_PCI=Y (PCI support)

CONFIG_PC300=Y or M select with '*' or 'm' the option "Cyclades-PC300 support" under

"Network device support"

CONFIG_KERNELD=Y to allow module

autoloading.

select with '*' the option "Kernel daemon support" under

"Loadable module support" to allow module autoloading.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Sem comentários

Cyclades PR2000 Manual de Instalação Página 12