Cyclades PR2000 Manual de Instalação descarregar pdf (Página 13)

13Chapter 3 Software Installation

For kernels 2.2.x:

CONFIG_PCI=Y (PCI support) and

CONFIG_EXPERIMENTAL=Y

select with '*' or 'm' the option "Development and/or incomplete

code/drivers" in the "Code Maturity Level Options" section.

CONFIG_HDLC=Y or M,

CONFIG_PC300=Y or M.

select with '*' or 'm' the option "Generic HDLC driver" under

"Network device support", "Wan interfaces", and then select

with '*' or 'm' the option "Cyclades-PC300 support"

CONFIG_KMOD=Y to allow module

autoloading.

select with '*' the option "Kernel module loader" under

"Loadable module support" to allow module autoloading.

For kernels 2.4.x:

CONFIG_PCI=Y (PCI support)

CONFIG_PC300=Y or M select with '*' or 'm' the option "Cyclades-PC300 support" under

"Network device support", "Wan interfaces"

CONFIG_KMOD=Y to allow module

autoloading.

select with '*' the option "Kernel module loader" under

"Loadable module support" to allow module autoloading.

For all kernels, if X.25 is to be used:

CONFIG_X25=Y or M,

CONFIG_LAPB=Y or M,

and CONFIG_PC300_X25=Y

enable X.25 support

to enable X.25 support, select with '*' the option "Cyclades-

PC300 X.25 support"; in the "Network Options" section select

with "*" the option "CCITT X.25 Package Layer" and select with

"*" the option "LAPB Data Link Driver"

After leaving “make config” or “make menuconfig”, execute the command

make dep

to set up the dependencies.

Rebuild and install the PC300 driver using any common kernel compilation and installation method. One such

method is typing the following command from the /usr/src/linux directory:

make bzlilo

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Sem comentários

Cyclades PR2000 Manual de Instalação Página 13