Cyclades AlterPath OnBoard Informações Técnicas Página 125

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 124
Administration Tasks Not Done in the Web Manager 85
Configuring VPN Connections
The OnBoard administrator must do the following tasks:
Make sure that the IPSec service is enabled.
Configure an IPSec VPN connection profile on the OnBoard.
Give the user a copy of the parameters used to configure the IPSec
connection profile on the OnBoard.
The OnBoard administrator can send a copy of the relevant portions of the
ipsec.conf file after the changes are saved and applied in the Web
Manager for the user to insert into the ipsec.conf file on the users
workstation.
The authorized user must do the following tasks:
Use the same values used by the OnBoard administrator to create an
IPSec VPN connection profile on the user’s workstation.
If the OnBoard administrator sends the relevant portions of the
ipsec.conf file from the OnBoard’s IPSec configuration, use it to
replace the same section in the workstation’s ipsec.conf file.
Ensure that routes are in place to allow IPSec communication with the
OnBoard and also to allow packets to the device to be routed through that
tunnel.
Create the IPSec VPN connection.
Note: If a virtual network has not been configured, the user may need to
create a separate tunnel to each private subnet they wish to access. If a virtual
network has been configured, the user needs only to create a single tunnel to
the virtual network.
Use either a browser or ssh on the command line to access the OnBoard,
using the OnBoard-side IP address assigned to the OnBoard; use the
OnBoard-side IP address configured when the private subnet or virtual
network to which the tunnel is connected was being configured.
Through the OnBoard, enable native IP access to the device.
Vista de página 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 501 502

Comentários a estes Manuais

Sem comentários