Cyclades AlterPath BladeManager Manual de Instruções descarregar pdf (Página 115)

Chapter 5: Using the Web Manager 101

4. If you select the Custom profile, make sure the checkboxes are checked next to services and

features you want to be enabled and make sure the checkboxes are clear next to services and

features you want to be disabled.

5. Click OK. The security profile confirmation screen appears.

6. Click Save and apply changes.

To configure services:

1. Select the Config

- Services menu option. The Config - Services screen appears with

checkmarks next to the services that have been enabled by default.

2. Enable or disable any of the listed network services by checking the checkboxes next to the

corresponding service.

3. Click Save and apply changes to enable or disable any selections.

Configuring Network Interfaces

By selecting the Config - Network - Host settings menu option, the administrative user can

configure the MergePoint 5224/5240 SP manager’s network interfaces and can configure DNS for

the SP manager.

Table 4.11 on page 40 shows the values to configure for network interfaces. Table 4.12 on page 41

shows the values to use when configuring Ethernet ports.

When configuring public Ethernet ports, be aware of the following:

• When DHCP is enabled for an interface and the DHCP server cannot be reached for any

reason, the interface IP address falls back to the factory default static IP address

(192.168.160.10) unless an administrator has assigned another IP address to the interface.

• When both interfaces are active and assigned two different IP addresses, both interfaces are

reachable through either IP address even if the cable is disconnected from one of the interfaces.

With failover enabled, the secondary Ethernet interface becomes bonded to the primary Ethernet

interface, and the bonded interfaces are referred to as a single bond0 interface. As a result, the same

set of values applies to the single bond0 interface.

Configuring primary and secondary Ethernet ports

If failover is disabled, the administrative user can configure each Ethernet port separately in the

following ways:

• Enable or disable each Ethernet port

• Enable or disable DHCP

• If DHCP is disabled, configure each port for static IP addressing

To configure the network interfaces:

1. Select the Network

- Host settings menu option.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 239 240

Sem comentários

Cyclades AlterPath BladeManager Manual de Instruções Página 115