Cyclades AlterPath BladeManager Manual de Instruções descarregar pdf (Página 32)

18 MergePoint 5224/5240 Service Processor Manager Installer and Administrator Guide

1. Eject the card.

2. If only one slot is currently in use, insert and configure the new card.

-or-

If both slots are in use, press the buttons next to both slots on the front of the SP manager. Then

insert and configure the new card.

Connecting an External Modem to the AUX Port

An external modem can be connected to the AUX port on the back of the SP manager and then

connected to the telephone network.

Figure 3.1: Connecting an External Modem to the AUX Port and to the Telephone Network

This procedure requires the following cables and connectors:

•A straight

-through CAT 5 or greater cable for connecting the AUX port to the external modem,

with an RJ

-45 connector on one end and the appropriate connector or adaptor (USB, DB-9 or

-25) on the other end

• A phone cord (for connecting the modem to a live phone line) with RJ

-11 connectors on

both ends

To connect an external modem to the AUX port:

1. Connect the RJ

-45 end of the cable to the AUX port on the SP manager.

2. Connect the other end of the cable to the modem.

3. Connect the phone cord between the jack on the modem and a live telephone jack at your site.

4. Configure the AUX port for PPP.

See To configure the AUX port for IPDU power management: on page 70 for details.

MERGEPOINT

5240

Telephone

Network

Dial-in

Users

Modem

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 239 240

Sem comentários

Cyclades AlterPath BladeManager Manual de Instruções Página 32