Cyclades AlterPath BladeManager Manual de Instruções descarregar pdf (Página 136)

122 MergePoint 5224/5240 Service Processor Manager Installer and Administrator Guide

# if it's hup term will be used to stop the daemon

# daemon command line parameters

DPARM="

-q priv0"

DSTOP=

9. Change the definition ENABLE=NO to ENABLE=YES.

ENABLE=YES # Must be "NO" or "YES"(uppercase)

10. Save and quit the file.

11. Save the configuration file changes by entering the

saveconf command.

12. Start dhcpd by either restarting the SP manager or restarting dhcpd.

The following screen example shows the syntax for restarting dhcpd.

[root@MergePoint5224 /]# daemon.sh restart DHCPD

Configuring Dial-ins Using cli

The following procedures give examples for configuring the two following types of devices

for dial

-ins.

• An external modem connected to an AUX port

• A modem, GSM or CDMA PC card installed in one of the front card slots. Configure the card

in slot 1 as modem0 and configure the card in slot 2 as modem1

See Table 4.13 on page 42 for the values you need to configure for each access type.

To configure an external modem or a modem, GSM or CDMA PC card using cli:

NOTE: Where cli commands set parameters for PCMCIA modem or phone cards, the cardtype is either

modem0, modem1, gsm0 or gsm1.

1. Log into the console as root.

2. Enter the

cli command.

3. If you are configuring an external modem, set the

auxport profile to modem.

4. Set the access

type to autoppp, login, ppp or otplogin.

The following example sets the access type of an external modem to ppp.

cli> set auxport profile modem OK

cli> set auxport modem type ppp

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 239 240

Sem comentários

Cyclades AlterPath BladeManager Manual de Instruções Página 136